sequences programmed).
IGNORE
ey used cannot at
INSERTED
ly.
a parasite, a
fault in the encoder or a short-circuit on the encoder
phases).
LAST
Displayed in
Displayed when the k (must not) be used
that time.
Indicates that the insertion has been made correct
Jitter
Error caused by the application of simultaneous edges on
the input encoder signals (can be provoked by
mode when the sequence shown is the
last of the product.
NEXT
Is displayed during successive display (
key) of the
sequences which exist in the buffer (except for the last
sequence which indicates END).
NO ACTIVE
Indicates an attempt to change to
or mode on
a sequence where the CY is programmed at 0.
NO PLACE
Indicates that the product list memory has no more space
available.
PAUSE
Axis pause.
PREVIOUS
Same as NEXT but with the
key.
RUN
Indicates that the transmission is being made correctly.
This message flashes slowly for the duration of the
transmission.
STOP
Indicates that the transmission has been interrupted by
means of the DNC STOP key.
STORED
Indicates that the storage operation has been made
correctly.
synchro
The maximum authorized separation (X1<->X2) has been
exceeded.
TEACH OK
The TEACH operation has been made correctly.
TIME OUT
Indicates that the DNC has not received any valid
information since the beginning of the transmission, and
thus returns the command to the operator. This message
appears after about 30 seconds.
TOL ZONE
Displayed in
or mode when the axes are
positioned outside of their tolerances. Generally, just press
the start of the front pannel to position the axes will do.
APPENDIX G: MISCELLANEAOUS PAGE 75
To Next Page
Loading...
