Getting Started
26
Default gateway: 192.168.0.1
Select Use the following DNS server addresses and enter:
Preferred DNS server: 192.168.0.1
Note
If you wish to retain your existing IP settings for this network connection, click Advanced
and Add the secondary IP address of 192.168.0.100, subnet mask 255.255.255.0.
Set up the CyberGuard SG appliance’s password and LAN connection settings
Launch your web browser and navigate to 192.168.0.1.
Select Quick Setup Wizard from the center of the page.
A log in prompt is displayed. Enter the initial user name and password for the
CyberGuard SG appliance:
User name: root
Password: default
Note
If you are unable to browse to the CyberGuard SG appliance at 192.168.0.1, or the initial
username and password are not accepted, press the black Erase button on the
CyberGuard SG appliance’s front panel twice, wait 20 – 30 seconds, then try again.
Pressing Erase twice within 2 seconds resets the CyberGuard SG appliance to its factory
default settings.
To Next Page
Loading...
Need help?
General
