CyberPower PDU31 Series User Manual

22
2. Advanced Power Management
Intelligent PDU Web Interface
Item Definition
Low Load Threshold
Set the value for the total current on the PDU that will
signal a low load warning. Must be lower than Near
Overload Threshold.
Outlet Restriction**
When load
current exceeds the corresponding threshold,
no outlets will be allowed to turn on.
*None: Users can turn on an outlet even if the device is in
Near Overload or Overload state.
*On Near Overload: Users cannot turn
on an outlet when
the device is in Near Overload or Overload state.
*On Overload: Users cannot turn on an outlet when the
device is in Overload state.
Power Restore
Peak Load Reset the peak load to zero.
Energy Reset the energy to zero.
ColdStart Configuration
ColdStart State
*Previous State: Outlets will return to the same state (on or
off) they were in prior to the PDU turning of
f. The
ColdStart Delay setting will apply when the PDU resumes
power.
*All On: All outlets will turn on when power is restored to
the PDU.
ColdStart Delay
*Instant: Outlets will be turned on immediately when power
is restored to the PDU.
*Wait: Outlets will be turned on according to this setting
when power is restored to the PDU.
*Never: Outlets will not be turned on when power is
restored to the PDU.
System Configuration
Idle Time
The PDU LCD
screen will turn off automatically after it
remains idle for the selected period of time.
**For some models, the Outlet Restriction only shows in the Bank Manager Page.

CyberPower PDU31 Series Specifications

General

Brand	CyberPower
Model	PDU31 Series
Category	Power distribution unit
Language	English