the contact heart rate grips. The left window will display the time elapsed. NOTE: During
your workout the time will show in the format of minutes:seconds. The right window will
display the current speed. See Figure 1.
9. Press the Speed
+ — keys to change the belt speed at any time. The right display will
show the set speed.
10. Press the Incline keys to change the incline at any time. The left display will show
the current incline only while it is adjusting, then revert to time elapsed.
11. Press the Stop key at any time to stop your workout. Press Stop once to end your
workout and begin your Workout Review. As you press Stop once, the treadmill will return
to 0% incline. Press Stop twice to clear the Workout Review and return to Dormant Mode.
12. If the e-stop key is removed during a workout, the power shuts off immediately, causing
the belt to stop. The right window changes to “OFF” and the left window shows a flashing
pattern of “
o
” and “
o
”. Replacement of the e-stop key causes Workout Review to begin.
13. When you complete a program the treadmill begins a countdown, “3...2...1,” and sounds a
tone for each count. The belt slows to a stop and Workout Review displays in the center
window for 20 seconds or until you press the Stop key.
14. The treadmill returns to Dormant Mode.
Stopping the Treadmill
Press Stop once to pause your workout for up to 20 seconds and to enter the Workout
Review. The belt will stop and the elevation will return to 0%, but time accumulated will
remain in memory for 20 seconds. Press the Quick Start key within 20 seconds to continue
Cybex Sport+ Treadmill Owner’s and Service Manual
Figure 1
Operation
Page 3-4
To Next Page
Loading...
Need help?
General
