Cybex Sport+ Treadmill Owner’s and Service Manual
! WARNING: All maintenance activities shall be performed by qualified personnel.
Failure to do so could result in serious injury.
For any service related concerns, call Cybex
Customer Service at 800-766-3211 (for Cybex
customers living within the USA). For
customers living outside the USA, call 508-
533-4300 or fax 508-533-5183.
NOTE: Read and understand each procedure
thoroughly before servicing. Unless otherwise
noted “right” and “left” denote user orientation
for all procedures.
Test Mode
To enter Test Mode press and hold down any key on the display while turning the power
switch to the on (I) position. When all keys are released the software revision “rx.x” is shown
on the display. The display automatically scrolls through the following data for three seconds
each:
rev, (revision) unit (unit of measurement), line (frequency), dist (distance or total miles), hour
(total hours), strt (number of starts), log (error codes 1-5). Afterward “TEST” appears on the
display. To exit Test Mode press Stop.
Stuck Key List
If Test Mode occurs without holding any keys, a key may be stuck closed or Error 7 may have
occurred. If “btn” (button) and a number is displayed you can determine which key is stuck
closed by referring to the list below. If a key is stuck closed you may need to replace the lower
display overlay. See Figure 1. Follow the Display Overlay procedure located in this chapter.
btn1 Stop
btn2 Incline Down
btn3 Speed -
btn4 Pace
btn7 Weight
btn8 Scan
btn9 Incline Up
btn10 Speed +
btn11 Quick Start
btn12 Cal
btn13 Level
btn15 Enter
btn16 Weight Loss
btn17 Dist
btn18 Adjust Down
btn20 Heart Rate
btn21 Manual
btn22 Mets
btn25 Adjust Up
btn26 Cardio
Figure 1
Upper
Overlay
Lower
Overlay
Service
Page 7-2
To Next Page
Loading...
Need help?
General
