Data displayed during a program: The top center display will continually review each set of
data. Each set of data is displayed for 3 seconds before the next set is displayed. The
corresponding LED lights as the data is displayed.
To review accumulated data after a program: The display automatically cycles through your
accumulated workout data during the Workout Review for up to 20 seconds.
Displaying Heart Rate
In order for the Cybex Sport+ to display your heart rate, hold the handgrips to use Contact
Heart Rate.
Contact Heart Rate — Hold the handgrips on the console crossbar until a heart rate is
displayed, typically less than thirty seconds. For best results, hold the handgrips lightly and
ensure that your hands contact both the front and back sensors of each grip. NOTE: Hold
your hands as steady as possible as movement can cause interference on the contacts.
Factors that can interfere with the heart rate signal include:
• excessive movement
• body composition
• hydration
• too loose grip
• too tight grip
• running
• excessive dirt, powder or oil
• leaning or resting on grips
NOTE: Cybex does not recommend continuous holding onto the contact heart rate grips
during exercise.
Contaminants, such as hand lotions, oils or body powder, may come off on the contact heart
rate grips. These can reduce sensitivity and interfere with the heart rate signal. It is
recommended that the user have clean hands when using the contact heart rate.
Cybex Sport+ Treadmill Owner’s and Service Manual
Operation
Page 3-7
To Next Page
Loading...
Need help?
General
