Cybex Sport+ Treadmill Owner’s and Service Manual
B. Gently pull off the console back.
3. Remove the old CSAFE board.
A. Pull the CSAFE connector out of the display board. See Figure 24.
B. Using a Phillips head screwdriver, remove the three screws that hold the CSAFE board
to the console.
4. Attach the new CSAFE board.
A. Gently push the CSAFE connector into its port on the display board. See Figure 24.
B. Using a Phillips head screwdriver, secure the CSAFE board with the three screws
removed during step 3B. NOTE: Do not overtighten.
5. Secure the console back.
A. While being sure not to pinch any cables, use a Phillips head screwdriver to secure the
nine screws that hold the console back to the console front.
Display Cable
Tools Required
• Phillips head screwdriver
• ESD (Electro Static Discharge) grounding strap
• Wire cutters
! WARNING: Disconnect the power cord before beginning this procedure. Keep wet
items away from inside parts of the treadmill. Electrical shock could occur
even if the treadmill is unplugged. Do not touch components on the lower
board. A charge can remain after unplugging the power cord and turning
off the treadmill.
1. Disconnect the external power source.
A. Turn the main power switch on the left side to the off (O) position.
B. Unplug the treadmill from the power outlet.
NOTE: The display board is susceptible to damage from a discharge of static electricity.
While handling parts underneath the console cover use an ESD grounding strap. This
eliminates the potential voltage (static) difference between you and the equipment you
are working on. Wear an ESD strap for the rest of this procedure.
2. Remove the console back.
A. Using a Phillips head screwdriver, remove the nine screws that hold the console back
to the console front.
B. Gently pull off the console back.
Service
Page 7-35
To Next Page
Loading...
Need help?
General
