Cybex Sport+ Treadmill Owner’s and Service Manual
Service
Page 7-31
5. Connect the cables.
A. Connect these cables into the display board: the display cable (2 connectors), the two
upper switch membranes, the lower switch membrane, the contact heart rate cable, the
CSAFE board to display board jumper and the upper to lower board jumper. See Figure 24.
6. Check the connections.
A. Check to see that all of the cables are connected firmly in their proper place.
7. Secure the console back.
A. While being sure not to pinch any cables, use a Phillips head screwdriver to secure the
nine screws that hold the back cover to the console front.
8. Calibrate speed.
A. Follow the Speed Calibration procedure located in this chapter.
Contact Heart Rate Board
NOTE: This procedure will cover the contact heart rate board, grips and cable.
Tools Required
• Phillips head screwdriver
• ESD (Electro Static Discharge) grounding strap
1. Disconnect the external power source.
A. Turn the main power switch on the left side to the off (O) position.
B. Unplug the treadmill from the power outlet.
NOTE: Wear an ESD strap for the rest of this procedure.
2. Remove the console back.
NOTE: If you have a cable plugged into the RJ-45 port disconnect it.
A. Using a Phillips head screwdriver, remove the nine screws that hold the console back to
the console front.
B. Gently pull off the console back.
3. Remove the heart rate board.
A. Using a Phillips head screwdriver, remove the three screws from the heart rate board.
B. If you’re not replacing the cable, disconnect the two cables and one molex placeholder from
the heart rate board. (You will re-attach the molex connector in step 4A). See Figure 25.
To Next Page
Loading...
Need help?
General
