Cybex 750T Treadmill Owner’s Manual
Preventive
Maintenance
Page 4-6
Service Schedule
All maintenance activities shall be performed by qualifi ed personnel. Failure to do so could result in
serious injury.
NOTE: This is the minimum recommended service.
1. Determine mileage.
While in A. Dormant Mode enter Statistics Mode by pressing the sequence CLEAR 999 and
ENTER. The ENTER key is active to advance to the next screen. The SPEED control keys are
also active to move forward or backwards in the menu.
Press theB. SPEED control keys to display “6-SERVICE” and miles or kilometers to the next
required service will be displayed.
Record Mileage.C. NOTE: Displays the count-down mileage to the next required service. Mileage
start at 15,000 miles (24,140 Km) and counts down to 0.
NOTE: To exit Statistics Mode, press the CLEAR key .
First 500 miles (800 km).
Check running belt tension and tracking.•
Every 5,000 miles (8,000 km).
Check running belt tension and tracking.•
Move treadmill and vacuum underneath.•
Raise elevation to 15%, carefully tip treadmill up on the console to clean underneath with a dry cloth •
and vacuum. Return to normal position when done.
Every 15,000 miles (24,140 km).
Replace running belt and fl ip deck.•
Check elevation assembly and replace worn parts.•
Lubricate elevation pivot points.•
Every 30,000 miles (48,280 km).
Replace running belt and deck.•
2. Resetting the service odometer.
While in A. Dormant Mode enter Statistics Mode by pressing the sequence CLEAR 999 and
ENTER. The ENTER key is active to advance to the next screen. The SPEED control keys are
also active to move forward or backwards in the menu.
Press theB. SPEED control keys to display “6-SERVICE” and miles or kilometers to the next
required service will be displayed.
Press and hold the C. CLEAR key for three seconds to reset the service odometer to 15,000 miles
(24,140 km).
NOTE: Service may be performed before the 15,000 miles (24,140 km) service prompt appears. Perform
the service on the unit and follow the above procedure to reset the service odometer to zero.