Cybex 750T Treadmill Owner’s Manual
Safety
Page 1-1
1 - Safety
IMPORTANT: Read all instructions and warnings before using the treadmill.
Important Voltage Information
Before plugging the power cord into an electrical outlet, verify that the voltage requirements for the site
match the voltage of the treadmill that has been received. The power requirements for the Cybex 750T
Treadmill include a grounded, dedicated circuit, rated for one of the following:
100 VAC, 50/60 Hz, 20A•
115 VAC, 60 Hz, 20A•
220 VAC, 60 Hz, 15A•
230 VAC, 50 Hz, 15A•
230 VAC, 50 Hz, 13A, UK•
See the serial number decal for the exact voltage requirements of the treadmill.
WARNING: Do not attempt to use this unit with a voltage adapter. Do not attempt to use this unit
with an extension cord.
WARNING: Do not plug more than one unit into a single circuit.
Grounding Instructions
This treadmill must be grounded. If it should malfunction or break down, grounding provides a path of
least resistance for electric current to reduce the risk of electric shock. This product is equipped with a
cord having an equipment-grounding conductor and a grounding plug. The plug must be plugged into
an appropriate outlet that is properly installed and grounded in accordance with all local codes and
ordinances.
DANGER: Improper connection of the equipment-grounding conductor can result in a risk of
electric shock. Check with a qualifi ed electrician or service provider if there is doubt as
to whether the treadmill is properly grounded. Seek a qualifi ed electrician to perform
any modifi cations to the cord or plug. Cybex is not responsible for injuries or damages
as a result of cord or plug modifi cation.
This treadmill is for use on a
grounded, dedicated circuit. Make
sure that the treadmill is connected
to an outlet having the same
confi guration as the plug. Do not
use a ground plug adapter to adapt
the power cord to a non-grounded
outlet.
115 VAC Euro Plug 220 VAC UK Danish
NEMA 5-20 CEE 7/7 NEMA 6-15 230 VAC IEC320
To Next Page
Loading...
Need help?
General
