Cyclades AlterPath BladeManager - Cli Commands

Working from a CLI
AlterPath BladeManager Manual 5-5
[Enter `^Ec.' to disconnect]
*******************************************************
CLI Commands
For your convenience, the CLI key commands (accessible by pressing ^Ec?)
are summarized in the table below. Each command must be preceded by ^Ec.
For example, to send a broadcast message, you must press: <Ctrl>Ecb
To exit from the CLI, press: <^> <shift>_
(i.e., <Ctrl> <Shift> <underscore>)
Key(s) Command Key(s) Command
.
disconnect
a
attach read/write
b
send broadcast message
c
toggle flow control
d
down a console
e
change escape sequence
f
force attach read/write
g
group info
i
information dump
l?
break sequence list
l0
send break per config file
l1-9
send specific break
sequence
o
(re)open the tty and log file
p
replay the last 60 lines
r
replay the last 20 lines
s
spy read only
u
show host status
v
show version info
w
who is on this console
x
show console baud info
z
suspend the connection
<cr>
ignore/abort command
?
print this message
^R
replay the last line
\ooo
send character by octal
code