5: Advanced Configuration
5-12 Alterpath BladeManager Manual
<session-timeout>60</session-timeout>
3. To make the change effective, reboot or restart tomcat as follows:
/etc/init.d/tomcat stop
/etc/init.d/tomcat start
Enabling Telnet
Telnet is available in the E2000, but disabled by default to avoid security
problems. To enable Telnet, follow the steps below:
1. From /etc/services, add the following line:
telnet 23/udp
2. Edit /etc/xinetd.conf as follows:
service telnet
{
flags = REUSE
socket_type = stream
wait = no
user = root
server = /usr/kerberos/sbin/telnetd
log_on_failure += USERID
}
3. Create /etc/protocols with the following content:
tcp 6 TCP # transmission control protocol
udp 17 UDP # user datagram protocol
4. To complete the procedure, restart xinetd with the following command:
/etc/init.d/xinetd.conf restart
Note: xinetd services will be available after reboot, since this script is already
included in the startup proceedure.
To Next Page
Loading...
