5: Advanced Configuration
5-6 Alterpath BladeManager Manual
Set Commands
The following set commands are available to enable you to manually and
individually configure specific E2000 settings through CLI:
• setauth
• setboot
• setcons
• setdatetime
•date
• setnames
• setnetwork
• setntp
• setsmtp
SETAUTH - sets the authentication method. For example:
[root@APM_Paulo root]# setauth
Your configuration will be overwritten by the default files!!
Are you sure you want to continue? (y/n)[n] y
Continuing setauth...
Choose the desirable authentication method local/radius/
tacacs+/ldap/kerberos/nis/active_directory) [local]:
*** Configuration changed!
*** Execute saveconf to save the new values in flash.
Note: If you select Radius as the authentication method, the system will
prompt you for other Radius servers to be configured, thus allowing
you to configure more than one Radius Server.
SETBOOT - sets the network boot utility. For example:
[root@APM_Paulo root]# setboot
NL4000 Network Boot Configuration Utility
-----------------------------------------
Current Status: DISABLED
Press <ENTER> if you wish to change it, or [Q<ENTER>] to quit:
Enter Local IP Address []:
Current Status: DISABLED
Do you wish to save these parameters? (y/N) n
*** Network boot parameters NOT saved
To Next Page
Loading...
