cycliq FLY6 PRO - Industry Canada (IC) compliance

33 of 35Fly6 PRO User Guide |
Industry Canada (IC) compliance statement
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two
conditions:
(1) this device may not cause interference; and
(2) this device must accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
Note
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
Radiation Exposure Statement
This equipment complies with Canada radiation exposure limits set forth for an
should be installed and operated
with minimum distance 20cm between the radiator & your body.
uncontrolled environment. This equipment
Déclaration d'exposition aux radiations
Cet équipement est conforme Canada limites d'exposition aux radiations dans un
Cet équipement doit être installé et utilisé à distance
minimum de 20cm entre le radiateur et votre corps.
environnement non contr?lé.