Cygnus 4 - Automatic Probe Detection

Cygnus 4 Operating Manual
M5-CYG4-M-01_Iss6.doc
36
Remember settings and calibration is saved with each probe
type. So if you change the probe type you may find a setting
has changed – this is normal.
The reason settings are saved with each probe type is so you
can swap probes during a survey without having to re-
calibrate each time.
Automatic Probe Detection
There is no automatic probe detection feature on this model of
gauge. You must select if manually from the list of probes. See
Selecting the Probe Type on page 35.