D-Link DCS-942L - Network Settings

32D-Link DCS-942L User Manual
Section 3 - Conguration
Network
This section allows you to congure your network settings.
Select this connection if you have a DHCP server running on your network and
would like a dynamic IP address to be updated to your camera automatically.
You may obtain a static or xed IP address and other network information from
your network administrator for your camera.
IPv4 Address: Enter the IP address that the camera will use on your network. You
may need to get this information from your ISP or network administrator.
Subnet Mask: The default value is “255.255.255.0.” Used to determine if the
destination is part of the same subnet.
Default Gateway: The gateway used to forward frames to destinations in a
dierent subnet. Invalid gateway settings may cause the failure of transmissions
to a dierent subnet.
Optional Primary DNS: Primary domain name server that translates names to
IP addresses.
Optional Secondary DNS: Secondary domain name server to backup the
Primary DNS.
If you are using a PPPoE connection, enable it and enter the User Name and
Password for your PPPoE account. You can get this information from your
Internet service provider (ISP).
Automatic IP
Address:
Static IP Address:
PPPoE Settings: