D-Link DES-3526 - Connecting DC Power to DES-3526 DC

DES-3526 / DES-3526DC Fast Ethernet Layer 2 Switch
11
Connecting DC Power to DES-3526DC
Follow the instructions below to connect the DC power supply of the DES-3526DC to the DC power
source.
Figure 2- 4. Power connections attached to contacts on assembly
1. Firmly attach the DC power to the negative and positive contacts on the wiring assembly.
• The negative pole (-) connects to the -48V contact.
• The positive pole (+) connects to the -48V Return contact.
• If available, earth ground may be connected to center contact post.
2. Tighten the contact screws so the connection is secure.