DES-3526 / DES-3526DC Fast Ethernet Layer 2 Switch
56
The default setting False, does not forward BPDU packets when STP is disabled.
State <Disabled>
This drop-down menu allows you to enable or disable STP for the selected group
of ports. The default is Enabled.
Click Apply to implement changes made.
Forwarding Filtering
Unicast Forwarding
Open the Forwarding Filtering folder in the Configuration menu and click on the Unicast For-
warding link. This will open the Setup Static Unicast Forwarding Table, as shown below:
Figure 6- 29. Setup Static Unicast Forwarding Table window
To add or edit an entry, define the following parameters and then click Add/Modify:
Parameter Description
VLAN ID (VID)
The VLAN ID number of the VLAN on which the above Unicast MAC address
resides.
MAC Address
The MAC address to which packets will be statically forwarded. This must be a
unicast MAC address.
Allowed to Go Port
Allows the selection of the port number on which the MAC address entered above
resides.
Click Apply to implement the changes made. To delete an entry in the Static Unicast Forwarding
Table, click the corresponding X under the Delete heading.
Static Multicast Forwarding
The following figure and table describe how to set up Multicast Forwarding on the Switch. Open the
Forwarding Filtering folder and click on the Multicast Forwarding link to see the entry screen
below:
To Next Page
Loading...
