DES-3526 / DES-3526DC Fast Ethernet Layer 2 Switch
77
Figure 6- 46. QoS Class of Traffic window
Once you have assigned a priority to the port groups on the Switch, you can then assign this Class to
each of the 4 levels of 802.1p priorities. Click Apply to set your changes.
Traffic Segmentation
Traffic segmentation is used to limit traffic flow from a single port to a group of ports on either a
single switch (in standalone mode) or a group of ports on another switch in a switch stack (Single IP).
This method of segmenting the flow of traffic is similar to using VLANs to limit traffic, but is more
restrictive. It provides a method of directing traffic that does not increase the overhead of the Master
switch CPU.
In the Configuration folder open the QoS folder and click Traffic Segmentation, to view the screen
shown below.
To Next Page
Loading...
