DES-3526 / DES-3526DC Fast Ethernet Layer 2 Switch
53
Figure 6- 26. MSTI Settings window
Parameter Description
Instance ID <0>
Displays the MSTI ID of the instance being configured. An entry of 0 in this field denotes
the CIST (default MSTI).
Internal cost
(0=Auto) <200000>
This parameter is set to represent the relative cost of forwarding packets to specified
ports when an interface is selected within a STP instance. The default setting is 0
(auto). There are two options:
• 0 (auto) - Selecting this parameter for the internalCost will set quickest route
automatically and optimally for an interface. The default value is derived from
the media speed of the interface.
• value 1-2000000 - Selecting this parameter with a value in the range of 1-
2000000 will set the quickest route when a loop occurs. A lower Internal cost
represents a quicker transmission.
Priority <128>
Enter a value between 0 and 240 to set the priority for the port interface. A higher
priority will designate the interface to forward packets first. A lower number denotes a
higher priority.
Click Apply to implement changes made.
STP Instance Settings
The following window displays MSTIs currently set on the Switch. To view the following table, click
Configuration > Spanning Tree > STP Instance Settings:
Figure 6- 27. STP Instance Table window
The following information is displayed:
Parameter Description
To Next Page
Loading...
