DES-3526 / DES-3526DC Fast Ethernet Layer 2 Switch
39
The user may set the following parameters:
Parameter Description
From/To
A consecutive group of ports may be configured starting with the selected port.
Mode
Active - Active LACP ports are capable of processing and sending LACP control
frames. This allows LACP compliant devices to negotiate the aggregated link so the
group may be changed dynamically as needs require. In order to utilize the ability to
change an aggregated port group, that is, to add or subtract ports from the group, at
least one of the participating devices must designate LACP ports as active. Both
devices must support LACP.
Passive - LACP ports that are designated as passive cannot initially send LACP
control frames. In order to allow the linked port group to negotiate adjustments and
make changes dynamically, one end of the connection must have "active" LACP
ports (see above).
After setting the previous parameters, click Apply to allow your changes to be implemented. The
LACP Port Table shows which ports are active and/or passive.
MAC Notification
MAC Notification is used to monitor MAC addresses learned and entered into the forwarding
database.
MAC Notification Global Settings
To globally set MAC notification on the Switch, open the following window by opening the MAC
Notification folder and clicking the MAC Notification Global Settings link:
Figure 6- 12. MAC Notification Global Settings window
The following parameters may be modified:
Parameter Description
State
Enable or disable MAC notification globally on the Switch
Interval (sec)
The time in seconds between notifications.
History size
The maximum number of entries listed in the history log used for notification. Up to
500 entries can be specified.
To Next Page
Loading...
