D-Link DIR-890L - Pptp

35D-Link DIR-890L User Manual
Section 3 - Conguration
Enter the PPTP Server IP Address provided by your ISP.
Enter the Username provided by your ISP.
Enter the Password provided by your ISP.
Select either Always on, On demand, or Manual.
Enter a maximum idle time during which the Internet connection
is maintained during inactivity. To disable this feature, enable Auto-
reconnect.
Select Static IP if your ISP assigned you the IP address, subnet mask,
gateway, and DNS server addresses. In most cases, select Dynamic IP.
Enter the PPTP IP Address provided by your ISP (for Static IP only).
Enter the PPTP Subnet Mask provided by your ISP (for Static IP only).
Enter the PPTP Gateway IP Address provided by your ISP (for Static
IP only).
Enter the Primary DNS Server IP address assigned by your ISP.
Enter the Secondary DNS Server IP address assigned by your ISP.
Maximum Transmission Unit - by default this eld will be set to
Auto. Select Manual if you need to change the MTU for optimal
performance with your ISP.
Click Save when you are done.
PPTP Server IP
Address:
Username:
Password:
Reconnect Mode:
Maximum Idle Time:
Address Mode:
PPTP IP Address:
PPTP Subnet Mask:
PPTP Gateway IP
Address:
Primary DNS Server:
Secondary DNS
Server:
MTU:
Choose PPTP (Point-to-Point-Tunneling Protocol) if your Internet Service Provider (ISP) uses a PPTP connection. Your Internet service provider (ISP) can
provide you with a username and password.
PPTP