D-Link DIR-890L - Pppoe

43D-Link DIR-890L User Manual
Section 3 - Conguration
PPPoE
Choose Share with IPv4 to re-use your IPv4 PPPoE username and
password, or Create a new session.
If you selected Create a new session above, enter the PPPoE
Username provided by your ISP.
If you selected Create a new session above, enter the PPPoE
Password provided by your ISP.
Select Static IP if your ISP assigned you the IP address, subnet mask,
gateway, and DNS server addresses. In most cases, select Dynamic IP.
Enter the IP Address provided by your ISP (for Static IP only).
If you selected Create a new session above, enter the ISP Service
Name (optional).
If you selected Create a new session above, select either Always
on, On demand, or Manual.
Maximum Transmission Unit - you may need to change the MTU for
optimal performance with your ISP.
Select either Obtain DNS server address or Use the following DNS .
If you selected Use the following DNS, enter the Primary DNS
Server address.
If you selected Use the following DNS, enter the Secondary DNS
Server address.
PPPoE Session:
Username:
Password:
Address Mode:
IP Address:
Service Name:
Reconnect
Mode:
MTU:
DNS Type:
Primary DNS
Server:
Secondary DNS
Server:
Select PPPoE (Point-to-Point-Tunneling Protocol) if your Internet connection requires you to enter a username and password. This information can
be provided by your Internet service provider (ISP). Required elds will vary, depending on the options you have enabled.*
Note: When you select Share with IPv4 and Dynamic IP instead of Create a new session and Static IP, less elds are required. See screen shot on the next page.