D-Link DSL-226 - Page 44

40D-Link DSL-226 User Manual
Section 4 - Conguration
NAT Enable:
Network address translation (NAT) translates private IP addresses to
public IP addresses before allowing private IP networks to connect
to the public network.
Authentication
Protocol:
Select the authentication protocol your ISP uses. The options are
Auto, PAP, or CHAP.
Enable PPPoE
Passthrough:
Enable or disable PPPoE trac to pass through this conguration. It
allows hosts behind the router to establish a PPPoE connection to
an external server.
G.Vector
This option raises VDSL2 connection's data date and cover range by
eliminating cross-talk in copper infrastructure. This is only available
for VDSL.
Connect Mode
Select:
Set the connection to be Always-on or Connect-On-Demand.
If you selected Connect-On-Demand, the following option is available:
Maximum Idle
Time:
Enter the amount of time in minutes the router will maintain the
Internet connection before disconnecting it if there is no activity.
IPv6 Settings
DHCP IPv6 Mode:
Select the IPv6 auto-configuration type: StateLess Address
AutoConfiguration (SLAAC) or Dynamic Host Configuration
Protocol (DHCP).
DHCP PD
Enable:
Enable or disable prex delegation.
MLD Proxy:
Multicast Listener Discovery (MLD) can be used to forward IPv6
multicast trac between another router and the hosts behind this
router.
Click Save when you are done.