D-Link DSL-226 - Connection Type: Pppoa

41D-Link DSL-226 User Manual
Section 4 - Conguration
Select PPPoA if your ISP provides and requires you to enter a PPPoA username
and password in order to connect to the Internet. This setting is only available
for ADSL WAN Connection Type.
WAN Settings
Connection:
Select PPPoA.
Protocol
Select IPv4, IPv6 or IPv4/IPv6 for both IPv4 and IPv6 addressing
mechanism. If you choosse IPv6, refer to the below IPv6 Settings.
Username:
Enter the username provided by your ISP.
Password/Conrm
Password:
Enter the password provided by your ISP. Then enter it again to conrm
your entry.
Connection Type
Select either PPPoA LLC or PPPoA VC-Mux as the encapsulation type
for the data.
Advanced Settings
MTU:
Maximum Transmission Unit - you may need to change the MTU for
optimal performance with your ISP. The default is 1492.
Usage:
Select None or Default Route to use this WAN connection type as the
default route.
NAT Enable:
Network address translation (NAT) translates private IP addresses to
public IP addresses before allowing private IP networks to connect
to the public network.
Authentication
Protocol:
Select the authentication protocol your ISP uses. The options are
Auto, PAP, or CHAP.
Connection Type: PPPoA