D-Link DSL-226 - Application

64D-Link DSL-226 User Manual
Section 4 - Conguration
Application
Port triggering allows ports to be opened for inbound trac when
outbound trac is detected on specied ports . This is used for facilitating
communication between applications and servers behind a NAT rewall. To
access this page, go to Features > Application.
The currently dened Application rules are displayed in the table. Some
commonly used Applications are pre-congured by default. If you wish to
remove an application rule, click . If you wish to edit an application rule,
click in the Edit column. If you wish to create a new application rule, click
the Add Rule button.
Create New Rule
Name:
Enter a name for this application.
Trigger Port Start:
Enter the starting port range for the trac that will be forwarded
(1-65535).
Trigger Port End:
Enter the ending port range for the trac that will be forwarded
(1-65535).
Trigger Trac
Protocol Type:
Select the protocol to trigger this rule: TCP, UDP, or All Protocol.
Open Port Start:
Enter the starting port to open once triggered (1-65535).
Open Port End:
Enter the ending port to open once triggered (1-65535).
Open Trac
Protocol Type:
Select the protocol to trigger this rule: TCP, UDP, or All Protocol.
Click Apply when you are done. A maximum of 16 rules can be dened.