D-Link DSL-226 - Static Route

69D-Link DSL-226 User Manual
Section 4 - Conguration
Static Route
The Static Routes page allows you to dene custom routes to control how data
trac is moved around your network. To access this page, go to Features >
Static Route.
If you wish to remove a rule, click in the Delete column. If you wish to edit a
rule, click in the Edit column. If you wish to create a new rule, click the Add
Rule button. Click Save when you are done.
Complete the following to create or edit a rule:
Create New Rule
Destination
Address:
Enter the destination subnetwork IP address.
Destination
Subnet Mask
(IPv4):
Enter the subnet mask of the destination address. The subnet mask
determines an IPv4 subnetwork.
Gateway IP
Address:
Enter your next hop gateway to be taken if this route is used. Or select
the interface to transit the packets of this static route. (Go to Settings
> Internet to obtain the congured WAN interfaces.) PVC denotes the
WAN port congured with ADSL service and PTM denotes the WAN
port congured with VDSL service.
Metric:
The route metric is a value from 0 to 15 that indicates the cost of
using this route.
Click Apply when you are done. A maximum of 16 rules can be dened.