D-Link DSL-226 - Page 72

68D-Link DSL-226 User Manual
Section 4 - Conguration
Destination IP
Address/Subnet
Mask/Port:
Enter the destination IP address (and subnet mask) and port that
the rule will apply to. Enter 0.0.0.0 for any IP address and 0 for any
port number.
Protocol: Select the network protocol for the trac: TCP, UDP, or ICMP .
Click
Set when you nished setting the rule. You can create up to 16 rules.
The created rule should be listed in the below table. To delete a rule, select
IP/MAC Filter
as the Filter Type, and select the respective Rule Index, then
click
Delete. To edit a rule, select the respective Rule Index, modify the
conguration, then click
Set.
Congure the following settings for URL ltering
:
Filter Type
Selection:
Select URL Filter.
Active: Select Yes or No to enable or disable URL ltering.
URL Index: Select the rule number for conguration (1-8).
Individual
Active:
Select Yes or No to activate or deactivate this ltering rule.
Rule Type: Enter the name for the website. This blocks access to websites based
on a website's address. For example, enter "ABC.com" or "www.ABC.
com." Or you may enter the corresponding IP address of a web server.
Click
Set when you nished setting the rule. You can create up to 8 rules.
The created rule should be listed in the below table. To delete a rule, select
URL Filter
as the Filter Type, and select the respective Rule Index, then
click
Delete. To edit a rule, select the respective Rule Index, modify the
conguration, then click
Set.