D-Link DSL-226 - Page 46

42D-Link DSL-226 User Manual
Section 4 - Conguration
Connect Mode
Select:
Set the connection to be Always-on, Connect-On-Demand, or
Manual.
If you selected Connect-On-Demand, the following option is available:
Maximum Idle
Time:
Enter the amount of time in minutes the router will maintain the
Internet connection before disconnecting it if there is no activity.
IPv6 Settings
DHCP IPv6 Mode:
Select the IPv6 auto-configuration type: StateLess Address
AutoConfiguration (SLAAC) or Dynamic Host Configuration
Protocol (DHCP).
MLD Proxy:
Multicast Listener Discovery (MLD) can be used to forward IPv6
multicast trac between another router and the hosts behind this
router.
DHCP PD
Enable
Enable or disable prex delegation.
Click Save when you are done.