Router Settings
The following table describes the labels in this screen.
LABEL
Router IP Address Enter the IP address you wish to use with your LAN here.
Subnet Mask
Enter the IP subnet mask you wish to use with your LAN here.
When you are making changes, click on Save Settings to save your
changes.
DHCP Server Settings (Optional)
The following table describes the labels in this screen.
LABEL
Disabled mode will not release IP address to a termination.
Enable
Enable mode will release IP address to a connected termination.
Relay Relay mode will relay to release IP address from a DHCP server
When you are making changes, click on Save Settings to save your
changes.
DHCP Server Settings (Optional)
Dynamic Host Control Protocol (DHCP), when enabled, gives out IP
addresses to a device that requests an IP address to be logged on to
22
To Next Page
Loading...
