D-Link DSL-2700U - Cant Access LAN Interface; Cant Access WAN Interface

1
If you have changed the password and forgotten it, you will need to upload the default
configuration file. This will erase all custom configurations and restore factory defaults,
including the password.
2
Press the RESET button for five seconds, and then release it. When the SYS LED
begins to blink, the defaults have been restored and the router restarts. Or refer
to the Resetting the router section for uploading a configuration file via console port.
3
The default username is “admin”. The default password is “admin”. The Password and
Username fields are case-sensitive. Make sure that you use the proper casing.
4
It is highly recommended to change the default username and password. Make sure
you record the username and password in a save place.
Can’t Access LAN Interface
I cannot access the router from the LAN or ping any computer on the
LAN.
STEPS
CORRECTIVE ACTION
1
Check the Ethernet LEDs on the front panel. A LAN LED should be on if the port is
connected to a computer or hub. If the 10M/100M LEDs on the front panel are both off.
2
Make sure that the IP address and the subnet mask of the router and your
computer(s) are on the same subnet.
Can’t Access WAN Interface
Initialization of the ADSL connection failed.
STEPS
CORRECTIVE ACTION
1
Check the cable connections between the ADSL port and the wall jack. The DSL LED
on the front panel of the router should be on.
2
Check that your VPI, VCI, type of encapsulation and type of multiplexing settings are
the
same as that you obtained from your telephone company and ISP.
3
Restart the router. If you still have problems, you may need to verify your VPI,
VCI, type of encapsulation and type of multiplexing settings with the telephone compan
y
and ISP.
61