D-Link DSL-2700U - Automatic Time Configuration; Set the Date and Time Manually

Daylight Saving Dates Select the DST start and DST end from the drop-down list.
When you are making changes, click on Save Settings to save your
changes.
Automatic Time Configuration
The following table describes the labels in this screen.
LABEL
DESCRIPTION
Automatically Synchronise with In
ternet
Time Servers
Choose how you want your device to obtain the time.
NTP Time Server
Enter the NTP server address you wish to use here.
A Network Time Protocol (NTP) server can automatically set the
router’s time for you. If you use an NTP server, you will only need to
select your time zone. If you manually set the time, you can enable
Daylight Saving. The router will automatically adjust when Daylight
Saving goes into effect.
When you are making changes, click on Save Settings to save your
changes.
Set the Date and Time Manually
Network Address Translation (NAT) translates the host IP address in
a packet used within one network to a different IP address known
within another network.
25