D-Link DSL-2700U - Cant Access Web Configurator; Forgotten Login Username and Password

3
Reset your ADSL line to reinitialize your link to the DSLAM.
4
If the problem persists, contact your local distributor for assistance.
Can’t Access Web Configurator
I cannot access the Web configurator.
STEPS
CORRECTIVE ACTION
1
Make sure you are using the correct IP address of the router. Check the IP
address of the router.
2
Make sure that a console session isn’t running.
3
Check that you have enabled Web service access. If you have configured a secured
client IP address, your computer’s IP address must match it. Refer to the chapter on
remote management for details.
4
For WAN access, you must configure remote management to allow server access from
the WAN (or all).
5
Your computer’s and the router’s IP addresses must be on the same subnet for
LAN access.
6
If you changed the router’s LAN IP address, enter the new one as the URL.
7
Remove any filters in LAN or WAN that block Web service.
The Web configurator does not display properly.
STEPS
CORRECTIVE ACTION
1
Make sure you are using Internet Explorer 5.0 or later versions.
2
Delete the temporary Web files and log in again.
In Internet Explorer, click Tools, Internet Options and then click the Delete Files ...
button. When a Delete Files window displays, select Delete all offline content and
click OK. (Steps may vary depending on the version of your Internet browser.)
Forgotten Login Username and Password
I forgot my login username or password.
STEPS
CORRECTIVE ACTION
60