D-Link DSL-5300 - Page 67

63D-Link DSL-5300 User Manual
Section 4 - Conguration
The DTIM (Delivery Trac Indication Message) interval set the wake-
up interval in power saving mode. The default and recomended
setting is 3 ms.
The Beacon Interval is the time in milliseconds between one DTIM
and the next. Lower this for unstable connections and roaming
devices. The default and recommended setting is 100 ms.
Transmission Bursting improves transmission speed between the
router and 802.11g devices. The default and recommended setting
is Enable.
Enable WMM APSD (Wi-Fi Multimedia Automatic Power Save
Delivery) to improve power management between wireless devices.
AMPDU (Aggregated-MAC Packet Data Unit) optimizes the number of
MSDUs (MAC Service Data Units) to avoid packet loss in error-prone
wireless channels.
Species the modulation scheme used for wireless transmission.
By default, wireless networks reduce speed to the slowest client. This
setting allocates time equally among clients, each running at their
highest speeds. The default setting is disabled.
Multi-User MIMO (Multiple Input Multiple Output) allows
transmissions to take multiple paths using multiple antennas,
dramatically increasing throughput. The default and recommended
setting is Auto.
Explicit Beamforming can be used when all clients support beam
forming, and allows use of channel estimation and direction steering
to improve link speeds.
DTIM Interval:
Beacon Interval:
Enable TX
Bursting:
Enable WMM
APSD:
Optimize
AMPDU
Aggregation:
Modulation
Scheme:
Aitrime
Fairness:
Multi-User
MIMO:
Explicit
Beamforming: