D-Link DSR-150 - Chapter 1. Introduction; Accessing the CLI

Unified Services Router CLI Reference Guide
8
Chapter 1. Introduction
This document describes the command line interface (CLI) for man aging D-Link's DSR-
1000N/1000/500N/500/250N/250/150/150N series of routers .
The CLI user requires advanced knowledge about the configuration of the system and should be
used only by those users who are familiar with CLI-based configuration.
 Note that the following features in the DSR Unified Services Router cannot be managed
by the CLI: Firmware Upgrade
 Configuration Backup / Restore
 Certificate Generate / Upload
 Power Savings mode configuration
 System Dashboard / Resource Utilization
Please access the web browser based UI of the DSR router for managing these features.
1.1 Accessing the CLI
The CLI can be acces sed by logging in with the s ame us er credentials as used to
access the web browser based UI.
********************************************
Welcome to the DSR Command Line Interface
********************************************
D-Link DSR>
 Note: D-Link DSR> is the CLI prompt.
 RIP, WAN2, DMZ, Captive Portal related commands are not available on DSR -
250N/250/150/150N.
 Wireless related commands are a vailable on DSR-1000N, DSR-500N, DSR-150N
and DSR-250N only.