Unified Services Router    CLI  Reference Guide 
 
121 
 
12.35  vpn sslvpn users users delete 
<ltrow_id>  
12.36  vpn ipsec policy configure <ltname>  
vpn policy configuration mode  
Save vpn policy configuration changes.  
Roll back vpn policy configuration 
changes.  
Save vpn policy configuration changes 
and exit current mode.  
Setting policy manual or auto  
Setting version ikev1 or ikev2  
general_ip_protocol_version  
Setting protocol version ipv4 or ipv6  
Setting ipsec mode for the vpn policy  
general_select_local_gateway  
Setting local gateway for the vpn policy  
general_remote_end_point_type  
Set mode to IP  address or Internet 
Name/FQDN  of the remote gatew ay or 
client PC   
 
vpn remote end point type 
The IP  address or Internet Name/FQDN 
of the remote gatew ay or client PC.  
general_remote_end_point ip_address  
The IP  address of the remote gatew ay or 
client PC.   
 
IPV4 or IPv6 address 
depending upon protocol 
selected IPV4 or IPV6 
general_remote_end_point fqdn  
The IP  address or Internet Name/FQDN 
of the remote gatew ay or client PC.  
general_enable_mode_config  
enable/disable mode config  
enable/disable this to allow NetBIOS 
broadcasts to travel over the VPN tunnel.  
Setting protocol esp or ah  
general_local_netw ork_type  
Select the IP  addresses on the local side 
that w ill be part of the tunnel. This can be 
either a single IP  address, several IP 
addresses in a range, an entire subnet, 
or any IP  address that w ants to connect  
general_local_start_address  
IP address from w here the range needs 
to begin  
 
IPV4 or IPv6 address 
depending upon protocol 
selected IPV4 or IPV6 
general_local_end_address  
IP address w here the range needs to 
end