D-Link DSR-150 - Routing Mode Settings

Unified Services Router CLI Reference Guide
62
7
priority
Helps to determine the OSPFv2
designated router for a netw ork.The
router with the highest priority w ill be
more eligible to become Designated
Router. Setting the value to 0, makes the
router ineligible to be come Designated
Router. The default value is 1.
Unsigned integer
8
hello_interval
The number of seconds for HelloInterval
timer value.Setting this value, Hello
packet w ill be sent every timer value
seconds on the specified interface. This
value must be the same for all routers
attached to a common network. The
default value is 10 seconds.
Unsigned integer
9
dead_interval
The number of seconds that a
device’s hello packets must not have
been seen before its neighbors declare
the OSPF router dow n.This value must
be the same for all routers attached to a
common network.The default value is 40
seconds.
Unsigned integer
10
cost
The cost of sending a packet on an
OSPFv2 interface
Unsigned integer
11
auth_type
Give the authentication type used for
OSPFv2.If Authentication type is none
the interface does not authenticate ospf
packets.If Authentication Type is Simple
then ospf packets are authenticated
using simple text key.If Authentication
Type is MD5 then the interface
authenticates ospf packets with MD5
authentication.
OSPF Authentication type
12
auth_key
Text Key for Simple Authentication type
String
13
md5_key_id
Give MD5 Key id
Unsigned integer
14
md5_auth_key
Give MD5 text key
String
8.39 net routing ospfv3 configure <ltinterface>
S.No
Command Name
Description
Type and Description
1
<ltinterface>
ospfv3 configuration mode.
2
save
Save OSPFv3 configuration changes.
3
exit
Save OSPFv3 configuration changes and
exit current mode.
4
cancel
Roll back configuration changes.
5
enable
Enable/Disable OSPFv3 for a particular
interface.
Boolean choice
6
priority
Helps to determine the OSPFv3
designated router for a network.The
router with the highest priority w ill be
more eligible to become Designated
Router. Setting the value to 0, makes the
router ineligible to beco me Designated
Router. The default value is 1.
Unsigned integer
7
hello_interval
The number of seconds for HelloInterval
timer value.Setting this value, Hello
packet w ill be sent every timer value
seconds on the specified interface. This
value must be the same for all routers
attached to a common network. The
default value is 10 seconds.
Unsigned integer