Unified Services Router    CLI  Reference Guide 
 
20 
 
Chapter  7.  Configure commands used 
in CLI 
The configure commands for all the branches mentioned above are d iscussed in this s ection. 
The  command  net  ?  at  the CLI prompt would give the description of all the configuration 
commands in the branch net, which is as follows: 
ipv6 tunnel configuration setup. 
net ipv6_tunnel six_to_four  
six to f our tunnel configuration setup. 
net ipv6_tunnel six_to_four configure  
six To Four Tunnel configuration mode. 
It gives options to add/edit/delete a bandwidth 
profile. 
net bandw idth profile enable <ltenable> 
It allow s to enable/disable bandwidth profiles.  
net bandwidth profile add 
It allow s to add a bandwidth profile. 
net bandwidth profile edit <ltrow_id> 
It allow s to edit a bandwidth profile. 
net bandwidth profile delete <ltrow_id>  
It allow s to delete a bandwidth profile. 
net bandwidth traffic_selector  
It gives options to add/edit/delete a traffic selector 
f or a bandwidth profile. 
net bandwidth traffic_selector add  
It allow s to add a traffic selector for a bandwidth 
profile. 
net bandwidth traffic_selector edit 
<ltrow _id>  
It allow s to edit a traffic selector for a bandwidth 
profile. 
net bandwidth traffic_selector delete 
<ltrow _id>  
It allow s to delete a traffic selector for a bandwidth 
profile. 
net lan dhcp reserved_ip configure 
<ltmac_address>  
DHCP  Reserved IPs add/edit mode. 
net lan dhcp reserved_ip delete 
<ltmac_address>  
Delete a specific reserved ip entry. 
DHCP  client configuration mode 
DHCP  client configuration mode 
net dmz dhcp reserved_ip configure 
<ltmac_address>  
DHCP  Reserved IPs add/edit mode. 
net dmz dhcp reserved_ip delete 
<ltmac_address>  
Delete a specific reserved ip entry. 
net ethernet configure <ltinterface_name>  
Ethernet configuration mode.