Unified Services Router    CLI  Reference Guide 
 
40 
 
This is the 64-bit subnet prefix that is 
assigned to the logical ISATAP subnet 
for this intranet.  
This is the endpoint address for the 
tunnel that starts w ith this router. The 
endpoint can be the LAN interface 
(assuming the LAN is an IPv4  netw ork), 
or a specific LAN IPv4 address  
 
select the local end point address 
type 
The local end point address if not the 
LAN IPv4 address  
 
IP address AAA.BBB.CCC.DDD 
w here each part is in the range 0-
255 
8.28 net ipv6_tunnel isatap delete <ltrow_id>  
isatap tunnel configuration mode.  
8.29 net routing mode configure  
Save NAT configuration changes.  
Save NAT configuration changes and exit 
current mode.  
Roll back Basic Security Level 
configuration changes.  
Select NAT or Classical Routing mode.  
8.30 net wan wan1 ipv4 configure  
Save ipv4 w an configuration changes.  
Roll back ipv4 w an configuration 
changes.  
Save ipv4 w an configuration changes 
and current mode.  
Select among the options: STATIC, 
DHCP  Client, PPPoE,  PPTP,  L2TP, 
Russian PPTP,  Russian L2TP, Japanese 
Multiple  PPPoE,  Dual Access Pppoe  
If ISP Type selected is DHCPC,  this field 
gives you options to configure DHCPC 
credentials  
Enter Yes to get dns dynamically from 
ISP  if you have not been assigned any 
static IP address. The ISP  w ill 
automatically assign an DNS address to 
the router using DHCP  netw ork protocol. 
Otherw ise Enter No and give valid static 
dns addresses  
Valid primary DNS Server IP Address  
 
IP address AAA.BBB.CCC.DDD 
w here each part is in the range 0-
255 
Valid secondary DNS Server IP  Address  
 
IP address AAA.BBB.CCC.DDD