DIR-620S Wireless N300 Router with 3G/LTE Support and
USB Port
User Manual
Configuring via Web-based Interface
In the Static IP Addresses section, you can specify MAC address and IPv6 address pairs (set a
fixed IPv6 address in the local area network for a device with a certain MAC address). The router
assigns IPv6 addresses in accordance with the specified pairs only when the Stateful value is
selected from the Mode of dynamic IPv6 address assignment drop-down list in the
Dynamic IPv6 Addresses section.
Figure 98. Configuring the local interface. The IPv6 tab. The section for creating MAC-IPv6 pairs.
To create a MAC-IPv6 pair, click the ADD button ( ). In the opened window, fill in the MAC
address field. You can choose a device connected to the router's LAN at the moment. To do this,
select the relevant MAC address from the drop-down list (the field will be filled in automatically).
Then in the IP address field, enter an IPv6 address which will be assigned to the device with the
specified MAC address. In the Hostname field, specify a network name of the device for easier
identification (optional). Click the APPLY button.
To create MAC-IPv6 pairs for the devices connected to the router at the moment, click the
KNOWN CLIENTS button. In the opened window, select the needed device and click the OK
button. To view the latest list of the connected devices, click the REFRESH button.
To edit the settings for the existing MAC-IPv6 pair, left-click the relevant line in the table. In the
opened window, change the needed parameters and click the APPLY button.
To remove a MAC-IPv6 pair, select the checkbox located to the left of the relevant line in the table
and click the DELETE button ( ). Then click the APPLY button. Also you can remove a MAC-
IPv6 pair in the editing window.
If needed, you can add your own address resource records. To do this, click the ADD button ( )
in the Hosts section (available if the Router, WISP Repeater, or Mobile Internet mode was
selected in the Initial Configuration Wizard).
Figure 99. Configuring the local interface. The IPv6 tab. The window for adding a DNS record.
In the IP address field, specify a host from the internal or external network. You can choose a
device connected to the router's LAN at the moment. To do this, select the relevant IPv6 address
from the drop-down list (the field will be filled in automatically). In the Name field, specify the
domain name to which the specified IPv6 address will correspond. Click the SAVE button.
Page 113 of 238
To Next Page
Loading...
