D16 Group PunchBOX - Distortion Effect; Distortion Parameters

To Next Page

To Previous Page

www.d16.pl

DESCRIPTION OF OPERATIONEFFECTS SECTION

Distoron

Distoron is controlled with the following set of parameters:

• Shape – Clipping curve selecon

• Tanh

• Atan

• Hard clip

• Crossover

• Asymmetric hyperbolic tangent

• Mixed Tanh and linear hard clip

• Dynamics – Signal compression rao before sending it to the Clipper

• Preamp – Signal amplicaon before it gets onto the Clipper. Amplicaon range: from 0 [dB] up to 48 [dB]

• Low Cut – Cut-o frequency of the passive high-pass lter that operates before the Clipper

• Contour – Clipper’s kneespan

• Tone – Overdrive tone characteriscs

• Volume – The resulng signal level from -inf [dB] up to 12 [dB].

• Distoron preset management secon

• Next/Prev – Navigaon through the Distoron preset bank. Loading of the next or previous preset

• Browser – Opens the Preset Browser (for more details on the operaon please refer

to the Preset Management chapter)

• Init (Prev + CTRL) – Restoring the inial eect values

• Reload (Next + CTRL) – Restoring the last loaded master preset (Master Preset) values

for the Distoron secon

• Save (Browse + CTRL) – Saving the current eect sengs as a preset

• FX Amount – Proporons between the Dry and Wet signals that will be sent to the next cascade eect.