DESCRIPTION OF OPERATIONGENERATORS SECTION
Generator Signal Roung - Send
By using Sends you can determine the proporon of the signal to be sent from each generator to the eect cascade or bypassed, i.e.
Sent directly to Master / Limiter. The Send parameters act as a cross-fader that determines the proporonal relaon between the signal
sent to the eect block and the signal that bypasses this block.
Send controls in the generators secon
The minimum value means that the whole signal of the specic generator is sent directly to Master / Limiter. The maximum value means
that the whole signal is sent to the rst cascade eect. The medium values determine the proporons between these two send variants.
The diagram below presents the topology of the send and direct outputs of the generators connected with the eects secon:
To Next Page
Loading...