Dacor DOC30M977D - Page 138

English138
Troubleshooting
Troubleshooting
Symptom Cause Action
Optitray
While turning, the
optitray comes out
of place or stops
turning.
There is no roller ring, or the
roller ring is not properly in
place.
Install the roller ring and then
try again.
The turn table drags
while turning.
The roller ring is not properly
in place, there is too much food,
or the container is too large
and touches the inside of the
microwave.
Adjust the amount of food. Do
not use containers that are too
large.
The turn table
rattles while turning
and is noisy.
Food residue is stuck to the
bottom of the oven.
Remove any food residue stuck
to the bottom of the oven.
NQ9300M_MOD_DOC30M977D_DE68-04463A-01_EN.indd 138 5/2/2017 4:00:09 PM