10-10
FRONT WHEEL/FRONT FORK/STEERING
● Be sure that the bead is completely collapsed.
● In case of the tube type tire, insert the tire lever from
the opposite side of the valve and raise the bead over
the rim.
● On tubeless tires, insert the tire lever from the valve
side and raise the bead over the rim.
● Always use a rim protector when using tire levers.
·To avoid damaging the rim when using the tire lever,
always use rim protectors.
·Be sure to use motorcycle tire levers.
·Do not apply the mild detergent solution to the rim
and tire mating surfaces of low pressure tire. Apply
water only.
● Insert another tire lever at 30~50mm from the first tire
lever and remove the tire from the rim, little by little.
·Do not try to remove the bead too much at one time.
·Do not pry against or scratch the bead stopper area
with the tire lever.
● Repeat the above procedures until half of bead is
removed. Then remove the remaining bead by hand.
● Remove the tire from the rim.
To Next Page
Loading...
Need help?
General
