DAELIM a.four User Manual

12-11
BRAKE SYSTEM
● Install the primary cup with its concaved side toward
the inner side of the master cylinder.
● Install the snap ring.
TOOL : SNAP RING PLIERS
·When installing the cups, do not allow the lips to turn
inside out. (Refer to the drawing.)
·Note the installation direction of the snap ring.
·Be certain that the snap ring is seated firmly in the
groove.
● Install the rubber boot in the groove properly.
● Install the master cylinder to the handle bar.
·Install the holder with its “UP” mark facing upwards,
and align the holder joint with the punch mark on the
handle bar.
·Tighten the holder upper bolt first.
● Install the brake hose to the master cylinder with 2 new
sealing washers and the hose bolt.
TORQUE VALUE : 3.5kgf
·
m
● Connect the brake stop swtich wire.
● Fill the brake fluid, and bleed air.
● Install the rear handle cover. (
3-6 )
● Install the front handle cover. (
3-6 )
● Install the back mirror.
MASTER CYLINDER
MASTER CYLINDER
MASTER CYLINDER
MASTER CYLINDER
MASTER CYLINDER
MASTER CYLINDER
MASTER CYLINDER
MASTER CYLINDER
MASTER CYLINDER
MASTER CYLINDER
MASTER CYLINDER
MASTER CYLINDER
MASTER CYLINDER
MASTER CYLINDER
MASTER CYLINDER
MASTER CYLINDER
MASTER CYLINDER
MASTER CYLINDER
MASTER CYLINDER
MASTER CYLINDER
MASTER CYLINDER
MASTER CYLINDER
MASTER CYLINDER
MASTER CYLINDER
MASTER CYLINDER
MASTER CYLINDER
MASTER CYLINDER
MASTER CYLINDER
MASTER CYLINDER
MASTER CYLINDER
MASTER CYLINDER
MASTER CYLINDER
MASTER CYLINDER
MASTER CYLINDER
MASTER CYLINDER
MASTER CYLINDER
FILL THE
BRAKE
FLUID
FILL THE
BRAKE
FLUID
FILL THE
BRAKE
FLUID
FILL THE
BRAKE
FLUID
FILL THE
BRAKE
FLUID
FILL THE
BRAKE
FLUID
FILL THE
BRAKE
FLUID
FILL THE
BRAKE
FLUID
FILL THE
BRAKE
FLUID
FILL THE
BRAKE
FLUID
FILL THE
BRAKE
FLUID
FILL THE
BRAKE
FLUID
FILL THE
BRAKE
FLUID
FILL THE
BRAKE
FLUID
FILL THE
BRAKE
FLUID
FILL THE
BRAKE
FLUID
FILL THE
BRAKE
FLUID
FILL THE
BRAKE
FLUID

DAELIM a.four Specifications

General

Brand	DAELIM
Model	a.four
Category	Scooter
Language	English