DAELIM ROADWIN VJ125 - Cylinder Installation

10-6
CYLINDER / PISTON
CYLINDER INSTALLATION
● Make sure that the piston ring end gap is correct.
● Carefully remove any adhering gasket material from
the cylinder / head mating surface. Do not scratch the
surface.
● Install a new cylinder gasket and dowel pins.
● Coat the cylinder wall with clean engine oil and
lubricate the piston rings and install the cylinder.
● Tighten the cylinder bolt.
CYLINDER
CYLINDER
CYLINDER
CYLINDER
CYLINDER
CYLINDER
CYLINDER
CYLINDER
CYLINDER
CYLINDER
CYLINDER
CYLINDER
CYLINDER
CYLINDER
CYLINDER
CYLINDER
CYLINDER
CYLINDER
·Take care not to damage the cylinder mating surface.
·Be careful not to damage the piston rings.
·Be careful not to drop the cam chain into the
crankcase.
● Install the lower part of the cam chain guide to the “󳤆”
part of the crankcase, and install the cam chain guide
by aligning the projection part with the
“󳤆” part of
cylinder.
● Install the cylinder head. (⇨9-12 )
CAM CHAIN GUIDE
CAM CHAIN GUIDE
CAM CHAIN GUIDE
CAM CHAIN GUIDE
CAM CHAIN GUIDE
CAM CHAIN GUIDE
CAM CHAIN GUIDE
CAM CHAIN GUIDE
CAM CHAIN GUIDE
CAM CHAIN GUIDE
CAM CHAIN GUIDE
CAM CHAIN GUIDE
CAM CHAIN GUIDE
CAM CHAIN GUIDE
CAM CHAIN GUIDE
CAM CHAIN GUIDE
CAM CHAIN GUIDE
CAM CHAIN GUIDE
GROOVE
GROOVE
GROOVE
GROOVE
GROOVE
GROOVE
GROOVE
GROOVE
GROOVE
GROOVE
GROOVE
GROOVE
GROOVE
GROOVE
GROOVE
GROOVE
GROOVE
GROOVE
GASKET
GASKET
GASKET
GASKET
GASKET
GASKET
GASKET
GASKET
GASKET
GASKET
GASKET
GASKET
GASKET
GASKET
GASKET
GASKET
GASKET
GASKET