6-1
6. ENGINE REMOVAL/INSTALLATION
SERVICE INFORMATION
GENERAL SAFETY
Use a jack to remove or install the engine. Support the motorcycle with a jack firmly, taking precautions not to
damage the frame, engine, cable or harness.
Attach tape to the frame to protect it during the engine removal or installation.
● The following works can be serviced with the engine installed in the frame.
- Oil pump (section 3)
- Carburetor (section 4)
- Radiator (section 5)
- Clutch (section 7)
- Geashift (section 7)
- A.C. Generator (section 8)
- Starter clutch (section 8)
● The following works require engine removal for service.
- Cylinder head/valve (section 9)
- Cylinder/piston (section 10)
- Transmission (section 11)
- Crank shaft (section 11)
SPECIFICATION
TORQUE VALUES :
ENGINE HANGER BOLT (FRONT ) : 4.9㎏f·m (49N·m)
(REAR ) : 4.9㎏f·m (49N·m)
GEAR CHANGE ARM BOLT : 1.2㎏f·m (12N·m)
DRIVE SPROCKET BOLT : 1.2㎏f·m (12N·m)
LH. DOWNTUBE MOUNTING BOLT (SPECIAL BOLT) : 4.2㎏f·m (42N·m)
LH. DOWNTUBE BRACKET MOUNTING BOLT : 2.2㎏f·m (22N·m)
6
SERVICE INFORMATION
············
6-1
ENGINE REMOVAL
····················
6-2
ENGINE INSTALLATION
············
6-3
ITEM SPECIFICATIONS
ENGINE DRY WEIGHT 32.3kg
ENGINE OIL CAPACITY(AT DISASSEMBLY) 1.1ℓ
To Next Page
