DAELIM ROADWIN VJ125 - Fuel Tank Removal; Fuel Tank Installation

FUEL FILLER CAP
FUEL TANK COVER
FUEL TANK SEALING RUBBER FUEL UNIT
FUEL STRAINER
FUEL COCKFUEL TANK
FUEL CAP NECK
4-3
FUEL SYSTEM
FULE TANK
REMOVAL
INSTALLATION
● Install the fuel tank in the reverse order of removal.
● After installation, check if there is a gasoline leak.
● Remove the seat. (⇨12-2)
● Remove the fuel filler cap by looseing the 4 socket
bolts.
● Remove the fuel tank cover by looseing the 2
special screws and washer bolt.
● Remove the LH. side cover. (⇨12-2)
● Disconnect the fuel unit wire coupler.
● Place the fuel tank upside down.
● Disconnect the fuel tubes from the fuel tank.
● If fuel is in short supply at the fuel cock, remove the
gasoline in the tank, and clean the strainer screen by
loosening the fuel cock.
󳢯Do not smoke or allow flames or sparks in the
work area because gasoline is extremely
flammable. Immediately wipe off a leaked
gasoline.
SOCKET BOLTS
SOCKET BOLTS
SOCKET BOLTS
SOCKET BOLTS
SOCKET BOLTS
SOCKET BOLTS
SOCKET BOLTS
SOCKET BOLTS
SOCKET BOLTS
SOCKET BOLTS
SOCKET BOLTS
SOCKET BOLTS
SOCKET BOLTS
SOCKET BOLTS
SOCKET BOLTS
SOCKET BOLTS
FUEL TANK COVER
FUEL TANK COVER
FUEL TANK COVER
FUEL TANK COVER
FUEL TANK COVER
FUEL TANK COVER
FUEL TANK COVER
FUEL TANK COVER
FUEL TANK COVER
FUEL TANK COVER
FUEL TANK COVER
FUEL TANK COVER
FUEL TANK COVER
FUEL TANK COVER
FUEL TANK COVER
FUEL TANK COVER
FUEL UNIT WIRE COUPLER
FUEL UNIT WIRE COUPLER
FUEL UNIT WIRE COUPLER
FUEL UNIT WIRE COUPLER
FUEL UNIT WIRE COUPLER
FUEL UNIT WIRE COUPLER
FUEL UNIT WIRE COUPLER
FUEL UNIT WIRE COUPLER
FUEL UNIT WIRE COUPLER
FUEL UNIT WIRE COUPLER
FUEL UNIT WIRE COUPLER
FUEL UNIT WIRE COUPLER
FUEL UNIT WIRE COUPLER
FUEL UNIT WIRE COUPLER
FUEL UNIT WIRE COUPLER
FUEL UNIT WIRE COUPLER
FUEL TUBES
FUEL TUBES
FUEL TUBES
FUEL TUBES
FUEL TUBES
FUEL TUBES
FUEL TUBES
FUEL TUBES
FUEL TUBES
FUEL TUBES
FUEL TUBES
FUEL TUBES
FUEL TUBES
FUEL TUBES
FUEL TUBES
FUEL TUBES
󳢯Be careful not to damage the fuel tank.