DAELIM ROADWIN VJ125 - Regulator;Rectifier Removal;Installation; A.C. Generator Charging Coil Inspection

16-6
BATTERY/CHARGING SYSTEM
REGULATOR RECTIFIER
REGULATOR RECTIFIER
REGULATOR RECTIFIER
REGULATOR RECTIFIER
REGULATOR RECTIFIER
REGULATOR RECTIFIER
REGULATOR RECTIFIER
REGULATOR RECTIFIER
REGULATOR RECTIFIER
REGULATOR RECTIFIER
REGULATOR RECTIFIER
REGULATOR RECTIFIER
REGULATOR RECTIFIER
REGULATOR RECTIFIER
REGULATOR RECTIFIER
REGULATOR RECTIFIER
REGULATOR RECTIFIER
REGULATOR RECTIFIER
REMOVAL/INSTALLATION
● Disconnect the regulator/rectifier 6P coupler.
● Remove the regulator/rectifier unit mounting bolts and
regulator/rectifier.
● Install the reguator/rectifier unit in the reverse order of
removal.
A.C. GENERATOR CHARGING
COIL INSPECTION
● Remove the seat. (⇨12-2)
● Remove the LH. side cover. (⇨12-2)
● Disconnect the A.C generator cord coupler.
● Measure the resistance between the yellow leads.
RESISTANCE VALUE : 0.5~1.5
ΩΩ
(20
℃℃
)
● If the resistance values are much larger than the
specified value, or if there is continuity between
terminals and earth terminals, replace the stator with a
new one.
● Install in the reverse order of removal.
󳢯This test is done with the starter mounted to the
engine.
BOLTS
BOLTS
BOLTS
BOLTS
BOLTS
BOLTS
BOLTS
BOLTS
BOLTS
BOLTS
BOLTS
BOLTS
BOLTS
BOLTS
BOLTS
BOLTS
A.C. GENERATOR COUPLER
A.C. GENERATOR COUPLER
A.C. GENERATOR COUPLER
A.C. GENERATOR COUPLER
A.C. GENERATOR COUPLER
A.C. GENERATOR COUPLER
A.C. GENERATOR COUPLER
A.C. GENERATOR COUPLER
A.C. GENERATOR COUPLER
A.C. GENERATOR COUPLER
A.C. GENERATOR COUPLER
A.C. GENERATOR COUPLER
A.C. GENERATOR COUPLER
A.C. GENERATOR COUPLER
A.C. GENERATOR COUPLER
A.C. GENERATOR COUPLER