DAELIM ROADWIN VJ125 - Lubrication Points; Control Cable Lubrication

3-7
LUBRICATION
STEERING HEAD BEARINGS
DUST SEAL
WHEEL BEARING
(AT CHANGED)
SPEEDOMETER GEAR
BRAKE CALIPER
PIVOT
BRAKE PEDAL
PIVOT
REAR FORK
PIVOT
WHEEL BEARING
(AT CHANGED
DUST SEAL)
DRIVE CHAIN
(SAE#80or#90GEAR OIL)
THROTTLE GRIP
CLUTCH LEVER
PIVOTS
THROTTLE CABLE,
CHOKE CABLE,
SPEEDOMETER CABLE,
CLUTCH CABLE
BRAKE LEVER
PIVOTS
SIDE SAND
PIVOT
FRONT FORK DUST SEAL
LUBRICATION POINTS
Use general grease unless specified here.
Apply oil or grease to the other sliding surfaces not shown here.
CONTROL CABLE LUBRICATION
Periodically disconnect the upper end of the throttle cable and that of clutch cable, then apply oil after cleaning. Change it
when the cable lengthened.